|
|
|
|
 trying to converting a two wheel drive tranny
#811119
05/10/07 10:35 PM
|
Joined: May 2007
Posts: 2
OP
Need a Spot
|
i have what i think is a sm465 4 gear out of a 76' camper special. i have it in my mud truck now but i am having a hard time finding a np 205 case that will bolt up to it. i thought i counted 35 splines on the output shaft and the case i have now only has 28 (i think) i am new to chevy stuff so can anyone tell me what adaptor and t-case i need to complete this swap. any advise is very much apreciated!!
|
|
 Re: trying to converting a two wheel drive tranny
[Re: juks]
#811120
10/08/07 12:30 AM
|
Joined: Aug 2003
Posts: 612
Rock Warrior
|
You will need to totally disassemble your SM465 and swap out the output shaft. An SM465 for a 4WD application will use a 10 spline output which is shorter than the 2wd shaft and will mate to a 10 spline input NP205 with the appropriate adapter. (These parts should all be available from a junkyard) You can NOT use your existing output shaft. Check ebay.
2007 Ford F150 Supercab
|
|
|
|
|
|
OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
PHP: 7.4.33 Page Time: 0.005s Queries: 15 (0.004s) Memory: 0.5862 MB (Peak: 0.6337 MB) Data Comp: Off Server Time: 2026-06-07 04:39:17 UTCValid HTML 5 and Valid CSS