|
|
|
|
4Runner wont start at all!
#882143
04/22/08 04:37 AM
|
Joined: Feb 2003
Posts: 339
OP
Mudrunner
|
Post Undeleted 854Runner, pretty much stock engine and fuel system.
I parked to have dinner one night and afterwards it wouldn't start. Nothing was out of the ordinary. Here's what I know: I have spark. The fuel pump is not working. Using the jumper does not turn the fuel pump on. The AFM checked out OK. The circuit opening relay good. New Fuel Pump installed.
Where else do I look? I'm lost, please advise.
John
Last edited by Johnboy; 04/26/08 11:40 PM.
85 4Runner, 4" lift, bumpers, sliders, locker
|
|
Re: 4Runner wont start at all!
[Re: Johnboy]
#882144
04/22/08 04:49 AM
|
Joined: Jan 2000
Posts: 12,153
Web Wheeler
|
|
|
|
Re: 4Runner wont start at all!
[Re: 4Crawler]
#882145
04/26/08 10:37 PM
|
Joined: Feb 2003
Posts: 339
OP
Mudrunner
|
Test jumper didn't turn on the fuel pump... what else?
85 4Runner, 4" lift, bumpers, sliders, locker
|
|
Re: 4Runner wont start at all!
[Re: Johnboy]
#882146
04/26/08 11:29 PM
|
Joined: Apr 2002
Posts: 3,568
Roll Me Over
|
Do you have power to the fuel pump when you turn the key on?
The new pump could be bad. I would drop the tank and pull the pump to make sure it is working.
More than tread lightly. Leave it like you were never there, nor anyone else. '90 X-cab 4.88's 33 BFG AT's, rr ARB, Headers, Ignition upgrade, cold air induction. '91 X-cab 5.29's 315's BFG MT's, rr ARB, custom bumper and flatbed
|
|
Re: 4Runner wont start at all!
[Re: Snowtoy]
#882147
04/26/08 11:45 PM
|
Joined: Feb 2003
Posts: 339
OP
Mudrunner
|
No power when I turn the key on. I checked and there is no voltage going to the pump. Old one wasn't bad and the new one seems to be fine too.
I checked power to the circuit opening relay and got less than 1 volt. Will this open the relay? Perhaps this is the problem. Next place to check is the main EFI relay.
85 4Runner, 4" lift, bumpers, sliders, locker
|
|
Re: 4Runner wont start at all!
[Re: Johnboy]
#882148
04/27/08 12:39 AM
|
Joined: Jan 2000
Posts: 12,153
Web Wheeler
|
A 12 volt relay typically needs 6-9 volts to operate the coil and make it pull in the contact(s).
|
|
Re: 4Runner wont start at all!
[Re: 4Crawler]
#882149
05/03/08 05:45 AM
|
Joined: May 2008
Posts: 2
Need a Spot
|
Here is orders Iwould go: 1. Check battery (obviously it is ok if it cranks) 2. Check the fuel pressure by connecting a gauge to the fuel line nearby intake 3. Check plugs power by pulling a plug out and trying to short it to engine block. Power is there If you see the sparks Be very careful do not get yourself shocked 4. Timing belt will be next
Hope it helps. Good luck!
<img src="/forums/images/graemlins/kewl.gif" alt="" />
|
|
Re: 4Runner wont start at all!
[Re: datsun_73]
#882150
05/03/08 08:47 PM
|
Joined: Feb 2003
Posts: 339
OP
Mudrunner
|
I have definitely established that there is no fuel pressure and no voltage to the fuel pump.
Here are what I believe to be two major indicators of problems: 1: There was a ground cable disconnected 2: The EFI fuse plastic casing was partially melted but the fuse was not blown. If a surge of electricity hit the EFI and the fuse didn't blow, what got trashed??
Last edited by Johnboy; 05/03/08 08:49 PM.
85 4Runner, 4" lift, bumpers, sliders, locker
|
|
Re: 4Runner wont start at all!
[Re: Johnboy]
#882151
05/03/08 09:02 PM
|
Joined: Jan 2000
Posts: 12,153
Web Wheeler
|
Unlikely you had a "power surge", probably what happened with the melted part was a high resistance connection (due to corrosion or oxidation) and that makes heat (watts = amps * amps * resistance). So check for bad/dirty/loose connections at the fuse, and at any wire connections between the power source and device.
|
|
Re: 4Runner wont start at all!
[Re: 4Crawler]
#882152
05/03/08 10:37 PM
|
Joined: Feb 2003
Posts: 339
OP
Mudrunner
|
The schematic shows two fusible links between the EFI fuse and the battery. Any idea where those two are?
85 4Runner, 4" lift, bumpers, sliders, locker
|
|
|
|
|
|