|
|
|
|
Joint repair options...
#925899
01/14/09 06:43 PM
|
Joined: Jan 2004
Posts: 383
OP
Mudrunner
|
Have a '80 exhaust manifold tube (the one that bolts to the top of the manifold in two places with 4 bolts, and runs behind the head to a smog valve under the intake manifold) that was once cut. I want to make it servicable again by joining it someway. Other than welding, any suggestions on another solution?
'80 4X4 Longbed
|
|
Re: Joint repair options...
[Re: Stevie]
#925900
01/15/09 01:57 AM
|
Joined: Dec 2000
Posts: 882
Rock Warrior
|
junk yard for a new one.. you have pic an pulls right?
|
|
Re: Joint repair options...
[Re: missouriman]
#925901
01/15/09 04:03 AM
|
Joined: Jan 2004
Posts: 383
OP
Mudrunner
|
|
'80 4X4 Longbed
|
|
Re: Joint repair options...
[Re: Stevie]
#925902
01/16/09 10:33 PM
|
Joined: Jan 2004
Posts: 383
OP
Mudrunner
|
Oh, a section of metal conduit maybe. Seems about the same size, huh? Solder may not hold due to high temps though.
'80 4X4 Longbed
|
|
|
|
|
|
OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
PHP: 7.4.33 Page Time: 0.007s Queries: 15 (0.005s) Memory: 0.6004 MB (Peak: 0.6555 MB) Data Comp: Off Server Time: 2026-06-09 23:16:48 UTCValid HTML 5 and Valid CSS