That rig looks so.cool... It would be easier to.run a carb too... Ok so can I use the same tranny and figure out a way to pair the engine and stick tranny together?? Plan to make lots of measurements tmanana..
There was a dude that put a mustang 5.0 FI motor in an 87/88 SWB about 15-20 years back, so yes its possible. He ran it for a while then put it into storage and sorta disappeared so not a lot of info exists other than we know he did it and posted pics that have since gone away.
99 Gen 2.5, fixing blown head gasket 89 SWB- 33's, ARB Front locker, SR rear locker/axle, SR F brakes, winch, WST Offroad Armor all Around, 2.85 Aussie T-case Gears (SOLD) Sold: (2) 95 SR's, 86 SWB, 90LWB, 91 LWB -Can Change a timing belt in my sleep..
Those jumpseats are too cool. I have a set from a Ranger that I want to fit in some day.
Big Truck: 00, 3.5, Endeavor, 5-Spd drive line in hand! Little Truck: 87, 2.6T I/C, MT, LSDs, Tonneau Top Her Truck: 03, 3.8, 20th Anniv, 65k Daughter's: 06 Eclipse, Keeping it Mitsu! FSMs: MitsubishiLinks.com
OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.