Extreme Terrain
4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums


Previous Thread
Next Thread
Print Thread
Rate Thread
Grease fittings Clean or replace? #1073916 08/24/14 05:55 PM
Joined: Dec 2004
Posts: 949
Monty Offline OP
Rock Warrior
Was going to lube all the grease fittings on the raider today, but only a few took grease. Found a tool for 50 bucks to clean them out. Or should I just replace them? If I do replace what size are they?


1989 Raider V6/MT
2005 Jeep Liberty CRD Turbo Diesel
Re: Grease fittings Clean or replace? [Re: Monty] #1073917 08/24/14 06:03 PM
Joined: Feb 2005
Posts: 7,458
rxinhed Offline
Trail Leader
*****
Take a selection of the zerk fittings to your local parts store, you'll spend less replacing them.








4x4Wire Social:

| 4x4Wire on FaceBook |


OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

Powered by UBB.threads™ PHP Forum Software 7.7.3
(Release build 20190728)
PHP: 7.4.33 Page Time: 0.010s Queries: 15 (0.007s) Memory: 0.5867 MB (Peak: 0.6349 MB) Data Comp: Off Server Time: 2026-07-13 21:30:20 UTC
Valid HTML 5 and Valid CSS