Extreme Terrain
4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums


Previous Thread
Next Thread
Print Thread
Rate Thread
ignition control module 1992 d21 2.4 #1082573 05/11/14 03:46 PM
Joined: Mar 2008
Posts: 95
B
bearingman Offline OP
Getting the Wheeling Fever
Can anyone advise where this is located? Auto Zone component location said behind driver's side headlight. Coil is there. I thought these were in distributor. Cranks fine when cold, but must sit hours before restart.

Is mounted on bottom side of coil, under a bunch of crap, of course. Didn't have enough light/downtime to swap it out yet. 4 day weekend coming, so I should be good to go

Last edited by bearingman; 05/21/14 09:08 PM.
Re: ignition control module 1992 d21 2.4 [Re: bearingman] #1082574 06/08/14 01:33 AM
Joined: Mar 2008
Posts: 95
B
bearingman Offline OP
Getting the Wheeling Fever
got it swapped out rather easily once I could see what I was doing. Cranks fine. Later went ahead and changed dist cap and rotor. Also changed out a vacuum line I found with 2 holes in it. Runs better and a little better on gas too.


Moderated by  4x4Wire, Dandeman, Mike Bondi 







4x4Wire Social:

| 4x4Wire on FaceBook |


OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

Powered by UBB.threads™ PHP Forum Software 7.7.3
(Release build 20190728)
PHP: 7.4.33 Page Time: 0.010s Queries: 15 (0.008s) Memory: 0.5840 MB (Peak: 0.6320 MB) Data Comp: Off Server Time: 2026-07-14 06:42:04 UTC
Valid HTML 5 and Valid CSS