Extreme Terrain
4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums


Previous Thread
Next Thread
Print Thread
Rate Thread
Page 2 of 2 1 2
Re: broken rear glass/defroster AGAIN [Re: hunterdan] #433801 04/13/04 10:32 PM
Anonymous
Unregistered
ya the insurance i have does not cover the rear glass

the glass guy that came out said he replaces rear window on rodeo all the time he said that the rear window is a poor design and isuzu know about it b/c he's repaired them at dealerships before

he said that the newer rodeos have a total of 15 holes in the rear glass(hinges light etc...)he said all the hole create weak edges and stress will cause it to shatter and he also said that an extreme tempeture changes(like the 1st time my window broke)will cause the glass to break(like if the windows iced over and you throw hot water on it ......)



who know??????

/ new window was 300 bucks and i banned the wife from driving the truck lol

Re: broken rear glass/defroster AGAIN #433802 04/14/04 01:07 AM
Joined: Dec 2001
Posts: 2,652
W
Wayne Offline
Roll Me Over
The rear defroster is a series of resistors in parallel.
If you cut one (remove a parallel resistor), the total resistance goes UP.
I (total current) = Voltage /Resistance
As resistance goes up (and 12v remains constant), total current would go DOWN.

What you are concerned with is Power to defrost at a single point--a hotspot. What does cutting out one element do to the rest?
P = I * E = I^2 * R = etc.

This is a passive device--which an active device (such as an amplifier) I'd say it would burn out.

For a passive device, while TOTAL current current goes down, current in the individual remining those lines might go up slightly (need to simulate). So if you cut it down to one line, for example, it could get very hot and burn up the line. Or make a hot spot that cracks the glass on a cold day.

Plus tint would insulate slightly, holding the heat inside. I don't know for certain. I'll have to simulate.


[color:"white"]? 04 Rodeo DI ?[/color] 75k mi, body damage on the 1st weekend I got it.
Re: broken rear glass/defroster AGAIN [Re: hunterdan] #433803 04/15/04 08:00 AM
Joined: Feb 2004
Posts: 315
H
hlhneast Offline
Mudrunner
I had my Honda tinted in Fla. recently and I wanted to do the sunroof with a really dark tint. The installer told me he wouldnt do it because the tint on a tinted window will make it shatter. Something about the expansion of the window against the tint at high temps. I didnt do it for that reason.


77 fiberglass CJ-7 304, Ground up Resto-mod Edelbrock Air Gap, Holley 1850, Headers and Flowmasters, Black Diamond suspension, BFG 33X9.50 on Outlaw I's. Hopefully on the road this year!
Re: Isuzu TSB regarding tint [Re: hlhneast] #433804 04/20/04 08:58 PM
Joined: Sep 2002
Posts: 326
C
Canucklehead Offline
Mudrunner
Tailgate glass - Breakage After Tint Film Installation
BULLETIN NUMBER:
IBOO-S009

GROUP:
IN FORMATION

ISSUE DATE:
FEBRUARY 2000

TAILGATE GLASS BREAKAGE AFTER INSTALLATION OF AFTERMARKET FILM TINT MATERIAL

AFFECTED VEHICLES

1996 - 1997 Rodeo (UC)
1998 - 1999 Rodeo (UE)

SERVICE INFORMATION

Some aftermarket tint installers may scratch the heating element (defroster lines) or etch the glass (start of the break area) during installation, from affixing aftermarket film tint material to the tailgate glass. Because of the scratches made during installation, the scratched heating element suffers semi-disconnected condition and the resistance increases on the operating defroster lines. Also, some aftermarket tint installers may choose to uninstall the heating terminals while affixing aftermarket film tint material to the tailgate glass and reinstall the heating terminals loosely. This leads to abnormally high heating condition and may result in glass breakage.

NOTE: Some tailgate glass breakage may result from incorrect tailgate closing sequence. See "Tailgate Operation" under Interior Features in the Vehicle Owners Manual for opening and closing procedures.

In order to avoid costly replacement of tailgate glass, the customer should be made aware of the above information and proper tailgate operation.


Steve

'97 Rodeo 5spd. 3.2L SOHC V6 4WD
Re: Isuzu TSB regarding tint [Re: Canucklehead] #433805 04/20/04 10:18 PM
Anonymous
Unregistered
thanks steve i was looking for something like that

My shattering experience #433806 01/25/05 08:40 PM
Joined: May 2004
Posts: 228
R
rheteric Offline
Wheeler
I just had my rear glass shatter on me today. The car was sitting in the garage overnight at sub-freexing temperatures here in the northeast. It shattered as soon as I got in and closed my door. The glass must have been under such tensile stress that the shock from the door blew it up. I do have aftermarket tint. It was installed by the previous owner and it looked very professionally done. I read about this issue before so I've always been gentle with the glass, but my wife has a habit of slamming it. I thought this would never happen since it had always handled her abuse, but low and behold it doesn't even take a key in the ignition to break this glass.

My defroster never defrosted evenly. It always worked well on the upper 1/3 of glass but took much longer to defrost the lower. When I took delivery of the car, one of the wires was disconnected on one side of the glass. Perhaps the previous owner was aware of the issue, but I unknowingly reconnected it (before reading about the issue) assuming that it was ovelooked by the dealer. The vehicle is a 2000 model Rodeo, and it went through 2.5 Philadelphia winters without a problem with me, so I figured my defroster was 'tint-friendly'. I never noticed any breaks in the wire tape but there may have been.

I did my shopping around and also found that safelite would offer me the best deal, $250. This includes on-site installation, cleanup and a lifetime warranty. Of course I opted for the glass with tint already in place. I was amazed at how competitive the autoglass industy is as I essentially had 3 different dealers bidding for my business. I got prices from safelite, autoglass national, and triumph autoglass, all of which were well below the quote I recieved from a local dealer of $400. The only issue is that I have to wait until tomorrow morning for installation, but that's worth my $150.

I can't really place the blame on any single component. I don't think the defroster is any more to blame than the tint installation. It has been very cold nonstop, below freezing this past week (plus), however my garage tends to be warm enough to melt the snow off of my car. I have to speculate that the changes in temperature eventually weakened the glass and the first place to fracture was around the tint. It's definitely not the "electrical current" issue, since the defroster wasn't even on, however, using the defroster in a few freeze/thaw cycles might have an impact on the temperature-sensitivity of the glass. Irregardless, there is definitely a flaw in the design of this glass (thickness, curvature, holes, etc.) which should have been rethought before mass-production. Fortunately this was a small price to pay for an otherwise problem-free 4x4.
-Eric


www.burnlounge.com/mp3me
'00 Rodeo LS 4x4; "K&N" cone filter; S/S Manik Front, Rear, & Nerf; 'Modest' sound system; 1.5" R'ooper lift, 265/70/16 Dunlop RVxt, Skyjacker Hydros, OEM LSD (sans G80 code)
Re: My shattering experience - update [Re: rheteric] #433807 01/26/05 10:59 PM
Joined: May 2004
Posts: 228
R
rheteric Offline
Wheeler
Safelite came today to repair my glass. The tech took a look at the molding around the edge of the glass and says he can't do it. Their glass doesn't come with the molding and he wouldn't install it without; it couldn't be reused due to the glue, shards, etc. A call to their offices revealed that it would have to be ordered from Isuzu, would take about a week to recieve, and would cost an additional $50. I agree that the molding is an essential part of the installation as this would buffer some of the shock through useage endured otherwise. Also, both of us are unsure/confused as to why there are no notes about it in the ordering process; this was also to be the case with my local glass dealer after consulting with them. I sent him on his way only to continue with my parts research. None of my local Isuzu dealers had the necessary parts, 3 in all, an upper and two sides. I finally put a call into St. Charles and am having them overnight the parts for a grand total of $50. So Safelite is coming out the morning after tomorow to install it.
What I am trying to explain in so many words is that if you have this problem:
1. Call Safelite, order the glass and setup installation for 2 business days later.
2. Call St. Charles, order the molding that goes aound the glass and have it overnighted.
3. Cross your fingers that there are no delays.
Also, having a price to match/beat is a good idea, mine was $250 from Triumph Autoglass, which Safelite was OK to match. Hope this helps someone.
-Eric


www.burnlounge.com/mp3me
'00 Rodeo LS 4x4; "K&N" cone filter; S/S Manik Front, Rear, & Nerf; 'Modest' sound system; 1.5" R'ooper lift, 265/70/16 Dunlop RVxt, Skyjacker Hydros, OEM LSD (sans G80 code)
Re: My shattering experience [Re: rheteric] #433808 07/23/11 07:57 AM
Joined: Jul 2011
Posts: 5
S
samsith Offline
Need a Spot
SPAM...

blah, blah, blah

Last edited by mlclark; 07/24/11 02:47 AM.
Page 2 of 2 1 2







4x4Wire Social:

| 4x4Wire on FaceBook |


OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

Powered by UBB.threads™ PHP Forum Software 7.7.3
(Release build 20190728)
PHP: 7.4.33 Page Time: 0.013s Queries: 16 (0.009s) Memory: 0.6307 MB (Peak: 0.7503 MB) Data Comp: Off Server Time: 2026-11-17 11:18:11 UTC
Valid HTML 5 and Valid CSS