|
|
|
|
ARB Bull Bars ??????????????
#641970
08/29/05 08:38 PM
|
Joined: Feb 2004
Posts: 26
OP
Getting the Wheeling Fever
|
Does any one know if you can install an ARB front bumper (winch bull bar) on a tacoma with a 3" body lift. if any body has done that and has pics i would like to see them. Thanks, EDS
Last edited by EDS2000tacoma; 08/29/05 08:40 PM.
Eric S.
2000 Tacoma -6in of lift,33x12.50 truxx's M/T's
|
|
Re: ARB Bull Bars ??????????????
[Re: EDS2000tacoma]
#641971
08/29/05 10:56 PM
|
Joined: Aug 2001
Posts: 5,986
Toyota Section Staffer
|
Sure... with a welder and fab skills. It will not install without modification. But anything is possible with a torch and MIG.
-Bill '87 4Runner w/ '96 5VZ-FE, 'Red Chili II' '97 Taco XtraCab 3RZ-FE, 'BlackBean' TLCA # 13257, Rising Sun 4x4 Club Land Use Coordinator "He who stops being better stops being good." -Oliver Cromwell
|
|
|
|
|
|
OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
PHP: 7.4.33 Page Time: 0.006s Queries: 15 (0.004s) Memory: 0.5899 MB (Peak: 0.6378 MB) Data Comp: Off Server Time: 2026-06-10 01:31:53 UTCValid HTML 5 and Valid CSS