Hi I'm new at posting but been reading for a while now. Does any one have any advice or experience at installing a remote care starter on a 98 Rodeo..Or could refer me to any web sites that may have info. please and thank you. I just purchased a new Jensen JKRS3 remote car starter and would like to install it my self..Any help would be appreciated.

Thanks

Ryan

Do you have factory keyless entry and alarm? I don't think they started chipping the keys until 2000, but if your factory system uses an RFID key system to prevent hotwiring you'll need a bypass module.

If all these answers are no, did the system you bought come with alarm and keyeless entry? Of course that makes it a bit more complicated.

Start with a subscription to www.alldatadiy.com

You pay $25 and you can get the wiring diagram for every circuit in your vehicle to help you identify what wires to tap into.

the rest I would assume is following teh directions that came with the kit. I am going to deal with my girlfriends' jetta after Xmas.

thanks for the reply, it has the keyless entry and factory alarm and yes my alarm does have the alarm bypass.

Here's a wiring diagram for a 1998 Isuzu Rodeo , Hope this helps!

http://www.directwholesale.net/diag...6&MakeID=23&link=BULLDOG

I found this at www.bulldogsecurity.com they make security and remote start systems. They have a lot of good info to help with the installation of their systems so I'm sure a lot of it will help with any brand out there.

- Ryan