I was out working on my fuel cell today , and am ready to mount it up , but with the adapters and hoses on the top of the cell , it sticks up 4.5" over the top of the cell.Now , what I am looking for , is where the top of the stock tank sits , and how much room is between it and the body.I didn't take those measurements before I took my trucks apart <img src="/forums/images/graemlins/smile.gif" alt="" /> Anyway , if I know those , I can adjust the cell accordingly by those numbers , then factor in my body lift.It would be muchly appreciated <img src="/forums/images/graemlins/cheers.gif" alt="" />

I get right at 2inches measuring at the body support and less then 1/2inch under the support. There's 5 1/4inches on the one I have with 3inch body lift.

When you say body support , are you talking the cushion mounts?Or are you saying beside that support , it sits flush with the frame?I just don't want to be off when I go to put the body on , and have to remove the feul cell and redo it all
<img src="/forums/images/graemlins/smile.gif" alt="" />

This is greatly appreciated by the way. <img src="/forums/images/graemlins/cheers.gif" alt="" />

Yes inside the frame rail by the body mounts the cross brace that runs from side to side. I measured about the middle of the tank to body floor the 1/2inch was at the bottom of the cross brace to tank. Your welcome anytime