Extreme Terrain
4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums


Previous Thread
Next Thread
Print Thread
Rate Thread
Head Gasket for 2.3l vs. 2.6l Head Swap #769326 12/03/06 06:08 PM
Joined: Jun 2005
Posts: 9
M
mgpman Offline OP
Need a Spot
I was going to swap an available and cheap 2.3L, 4zd1-c1, head onto my 1988, 2.6L, 4ze1, and I understand the probable increased compression, timing, etc. issues from my search on this great site, but my question is which head gasket should I use? For example, the Felpro 9496 for the 2.3 or the 8215 for the 2.6? Thanks


mgpman
88 Trooper LS
Re: Head Gasket for 2.3l vs. 2.6l Head Swap [Re: mgpman] #769327 12/03/06 06:33 PM
Joined: Sep 2003
Posts: 1,214
J
JLEMOND Offline
Body Damage is Cool
DON,T USE EITHER ONE , USE THE FACTORY GASKET FOR THE 2.6 , OR YOU WILL BE DOING IT OVER AGAIN IN A YEAR OR SO . JERRY








4x4Wire Social:

| 4x4Wire on FaceBook |


OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

Powered by UBB.threads™ PHP Forum Software 7.7.3
(Release build 20190728)
PHP: 7.4.33 Page Time: 0.007s Queries: 15 (0.004s) Memory: 0.5858 MB (Peak: 0.6336 MB) Data Comp: Off Server Time: 2026-06-17 03:39:22 UTC
Valid HTML 5 and Valid CSS