1. swap oil pans, and extend oil pickup tube approx 1".
2. remove ecu and all ecu wiring harness from truck with everything it connects to. (about an hour's job)
3. Take the dremel to the carb ecu box and open up one connector hole bigger and install starquest ecu.
4. Move firewall grommet on starquest fi harness to match carb harness (15min and some elec tape)
5. install sq harness to same clips as carb harness.
6. install sq spark box and coil
7. install sq inj resistor box near air cleaner.
8. install sq oil cooler and cut off steel lines at rubber line crimps and install new oil hose to banjo fittings with double clamps.
9. buy a Master E8000 electric fuel pump and install to round frame crossmember in front of fuel tank, and use FI fuel line and double clamps to hook to stock fuel lines.
10. install sq fuel filter and use FI fuel line and double clamps to hook to TB.
11. find an sq accel cable and mount to truck like old truck cable, but turn 1/4 circle guide tube approx 90* in plate to properly align with TB.
12. install motor.