I made some good progress tonight.

Starter installed
clutch line installed
ac brack and ac compressor installed
starion squash plate removed and cleaned.
front driveshaft installed
Carb harness removed and grommet cut off
Did a little more cleaning on the engine bay.
Installed a new valve in the head and lapped it
installed both manifolds.

Tomorrow I need to go buy a new oring for the squash plate, bleed the clutch and make sure the throwout bearing I installed will work. Fiund another starion os pump with resivoir and install, and then hopefully install the top end. I need to go buy some wire for the power and fuel pump also.

Hopefully I willg et a rear driveshaft soon. Would suck to get it running and have to drive it without the rear ds lol.