Here's a thread I started about installing the oil cooler from an SQ into my '89 SWB:

http://www.4x4wire.com/forums/showthread...rue#Post1214030

I only had to drill a hole in the bracket on the oil cooler, and used an existing bracket on the front side of the radiator. Cut off the metal tubes and used new rubber oil lines and double-clamped the ends. The pics show the results. Since mine is a manual trans, there was lots of room to work with on the front side of the radiator. If yours is an automatic, maybe not so much...


1989 Monty SWB, 2.6L w/MT, 15" alloys, 265/75 Dunlop Radial rovers, rear air shocks, Weber 32/36, SQ oil cooler, (SOLD Oct 2012)
Southeast VA, USA