Adapter Machining Questions

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: Adapter Machining Questions [Re: monte] #1004966 08/02/10 05:26 AM

Joined: Feb 2005

Posts: 1,511

Phoenix, AZ

ryany

Body Damage is Cool

3.5 dohc lower intake butterfly valve shaft bushings - would probably want to be made of brass but I'm far from an expert on that sort of thing.

see this thread for info & pics

95 Montero SR
3.8 MIVEC, Advance headers, 2 1/2" exhaust, Magnaflow muffler, OME shocks & rear springs, 2" body lift, 3" tank lift, 4.90s, TRE front locker, factory rear locker, Roger Brown Rock Sliderz, 315/75r16 (35") tires, Sport big brakes

Entire Thread
Subject	Posted By	Posted
Adapter Machining Questions	evileric	08/02/10 03:33 AM
Re: Adapter Machining Questions	monte	08/02/10 05:14 AM
Re: Adapter Machining Questions	ryany	08/02/10 05:26 AM

Moderated by 4x4Wire, Macka, Mudraider, off-roader, PHIL_, rxinhed

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 3.551s Queries: 16 (3.549s) Memory: 0.5969 MB (Peak: 0.6299 MB) Data Comp: Off Server Time: 2026-06-23 18:28:03 UTC
Valid HTML 5 and Valid CSS