how hard is it to put a 4.3 in a 87 ram 50

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: how hard is it to put a 4.3 in a 87 ram 50 [Re: hazy_daze] #1012420 11/09/10 06:44 PM

Joined: May 2001

Posts: 4,079

Apache Jct, Arizona,USA

lordtrunks Offline

Roll Me Over

If you want something easier to swap in 2.4 out of a 90's mighty max is pretty much a bolt on and you get mpi out of it and its lighter and spec'd with more power than the 2.6. I wired up the 2.4 in toasty's 94 montero he was missing part of the harness so if you had a donor it would be even easier cause you'd have the whole shot. just make sure its the wide block 2.4

89 2 dr turbo diesel
89/88 "Backwoods sas"

Entire Thread
Subject	Posted By	Posted
how hard is it to put a 4.3 in a 87 ram 50	Red1979	11/07/10 04:21 AM
Re: how hard is it to put a 4.3 in a 87 ram 50	hazy_daze	11/07/10 06:25 AM
Re: how hard is it to put a 4.3 in a 87 ram 50	lordtrunks	11/09/10 06:44 PM
Re: how hard is it to put a 4.3 in a 87 ram 50	willwinchforfood	11/10/10 06:28 PM
Re: how hard is it to put a 4.3 in a 87 ram 50	lordtrunks	11/10/10 10:15 PM

Moderated by 4x4Wire, Macka, Mudraider, off-roader, PHIL_, rxinhed

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 3.525s Queries: 16 (3.523s) Memory: 0.6021 MB (Peak: 0.6351 MB) Data Comp: Off Server Time: 2026-06-22 15:17:21 UTC
Valid HTML 5 and Valid CSS