Quote
I figured I'd have to pay attention to the CSB but didn't realize te hangle would be a problem, good note on that.
I wonder, though, if that thing could be shimmed to drop a little wit ha built-in angle at angle like we do axle perches to accomodate the angle. I'll probably add a leaf spring lift, or at least longer shackles, so that issue would come up anyway.


Problem with CSB, or rather that little upper shaft is that it typically has one u-joint and w/ 1 u-joint, you must run that shaft with 0 degree angle on that joint for no vibration. IOW, it must be dead in line with the t-case output flange or in whatever alignment it is now. If t-case is raise, CSB would need to be raised to match in most cases.

r.c.brown@ieee.org
TruckEditor@tlca.org
Project: 4Crawler
4Crawler OffRoad - 4x4Wire discount code