Do a search on ebay for 52mm UNIVERSAL BENDABLE TRIPLE GAUGE A PILLAR POD

I painted it with a grey that was close.

Removed the stock pillar cover, drilled a hole in it for the wires and JB welded the pillar pod to it and then filled in the gaps, sanded it and touched up the filler with some grey paint.

If you want a tight fit on the ends, you might try and heat the pod end carefully with a heat gun. Since the pod is ABS, you should be able to form it to the contour of the stock pillar cover. I will do that on the next one.

For the one on the dash, I just used a 52mm UNIVERSAL TRIPLE DASH GAUGE HOLDER MOUNT POD METER


I didn't like how it turned out because its surface isn't textured but it works.

I'm going to do my 2 door gauges with the pillar pod so I will try and document with pics in a new thread.


Everet