Valve build up

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: Valve build up [Re: fasteddy] #1016940 01/04/11 11:52 PM

Joined: Nov 2010

Posts: 95

Sanger, TX

RyanB

Getting the Wheeling Fever

Thanks everyone! I will wire brush it clean and inspect to make sure there are no cracks.

I was hoping that would be your answer, my block will cost me about $600 by the time I get it out of the engine shop. But still - I should have a good running Montero for a little over $1200 total.

Thanks again,
Ryan

1984 Mitsubishi Montero, 2.6l - 5 speed

Entire Thread
Subject	Posted By	Posted
Valve build up	RyanB	01/04/11 01:22 AM
Re: Valve build up	Engine_Machine_Ser	01/04/11 12:06 PM
Re: Valve build up	OldColt	01/04/11 04:46 PM
Re: Valve build up	fasteddy	01/04/11 05:45 PM
Re: Valve build up	RyanB	01/04/11 11:52 PM

Moderated by 4x4Wire, Macka, Mudraider, off-roader, PHIL_, rxinhed

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 3.507s Queries: 16 (3.505s) Memory: 0.6009 MB (Peak: 0.6339 MB) Data Comp: Off Server Time: 2026-06-15 05:40:54 UTC
Valid HTML 5 and Valid CSS