Both of the axle bearing are toast. I have them removed now. One side still had grease in there and the other side only has rust. I should have my axle needle bearings tomorrow and then I can get them installed and it all put back together.
My sporty has the air locking hubs, but, on my hub it looks as if they are locked in( meaning the spline part is all the way out and actually grabs the axle. Is this normal? Looking at the hub there is room for the spline piece to move back, I dont know if it does or not.

When I get it all back together and get the vacuum lines hooked back up, is there a chance that the vacuum will release the hubs?
As soon as I can I am getting different hubs.