Hello there, new to the board. I have looked and looked to not avail as to how to tighten up my 1998 Montero Auto transmission shifter assembly. Just picked up the rig with 130K, in pretty good shape- but the auto trans shift lever is sloppy both side to side and back and forth. The transmission itself is fine, and I am able to select all the gears just fine, lockout works ect... would just like it to feel a bit more "new" the transfer case selector is pretty sloppy as well, but again everything works. Not sure how to remove the center cosole to access the tunnel where I might need to tighten some stuff up, or if it is accessed from below. Any insight would be greatly appreciated. Thanks