Quote
Do you mean the outer snap ring at the hub and that it's not sticking out far enough that you can get the snap ring on?


That is correct Off Roader.

Any suggestions to what might be my problem? The only part of the job that I was not able to do by the book was pre-loading the wheel bearings with a spanowrench. I did not have one but I did get it as tight as I could and then backed off so and left it at the specifications.

I can't figure where there could be a problem. Not that I doubt you at all cause I am really good at coming up with creative problems! <img src="/forums/images/graemlins/scared.gif" alt="" />

Last edited by Darrell; 03/16/11 08:12 PM.