Well, Things are looking up for the old truck lloyd. We got it back on all 4's. Got the rear 3rd member all set back up with 4:90's and installed. The front passenger caliper was having an issue bolting back on cause for some reason the bolt got a little buggered. Jay solved that problem though and we got the caliper and tire back on. We also removed and reinstalled the steering set up (THE CORRECT WAY) to those who previously installed it, or attempted to anyway.

Here is a checklist that I have.

- Fill diff's with gear oil
- install cotter pins in all ball joints/tie rods
- Breather tub for transfer case
- Breather for front diff
- Block off all Vacuum lines from old front CAD
- Run air line for front ARB and install switch
- Finish wiring speedo deal
- finish wiring up compressor and mount it up
- Weld rear bumper
- install skid plates
- Fab up 4wd shifter box to fit montero
- Tuck back wiring from factory transfer case
- Getto alignment
- Final adjustment to torsion bars
- figure out high idle issue
- Coil spacers

Most of these projects will take 20 or 30 min a piece but I'm just trying to avoid forgetting anything since there has been a lot of working on something then working on something else then going back to something we were working on weeks or months ago.

Any chance there is anybody available next weekend on sunday? Lots to do and some of us will be out of town the following weekend. Would be nice to have some of this wrapped up if we can get some people over. <img src="/forums/images/graemlins/kewl.gif" alt="" />