Truck is getting there lloyd, all went well over all. Truck seems to run outstanding, lifter noise quieted down when we got it on the road for a long stretch. Probably the furthest its drove in the last several years. We did discover a leak out of the rear diff though. Pinion seal isn't holding. Were gonna need to replace that other than that everything else went just fine. Speedo gauge reads real accurate too. We are slowly inching away at it. I think the idle surge is gonna be a bit of a challange for us though. While we continue to chop away at other projects we need to keep brain storming that problem.

Here is a checklist that I have.

- Breather tub for transfer case
- Breather for front diff
- Run air line for front ARB and install switch
- finish wiring up compressor and mount it up
- Weld rear bumper
- install skid plates
- Fab up 4wd shifter box to fit montero
- Getto alignment
- Final adjustment to torsion bars
- figure out high idle issue
- Coil spacers
- Install new pinion seal

The list is a tad shorter with one more that I've added to it for the pinion seal. I should have suggested replacing that originally due to the fact that we removed that pinion flange 2 or 3 times. That seal was bound to get messed up.