- Breather tub for transfer case
- Breather for front diff
- Run air line for front ARB and install switch
- finish wiring up compressor and mount it up
- Weld rear bumper
- install skid plates
- Getto alignment
- Final adjustment to torsion bars
- Coil spacers
- Install new pinion seal

Seems we have figured out the high idle issue so I have removed that from the checklist. Also, the center consul is all back together with shifter box in place so we are good there. Not sure where we stand on some of the other stuff but we need to get that worked out. As of right now lloyd gets here in a week and a half. I know Adam will probably get the rear bumper on this week and the skid plates obviously wont work due to the crossmember flip. Pat are you going to go to adam's in the mornings after you get off of work or gonna work on it this weekend?

!!!!!!!!!!!!!WHAT ABOUT BOB!!!!!!!!!!!!!!!