As others here have posted, there is no after-market production of rear bumpers available in the USA for Gen III's- have to go custom fab., or look into shipping one over from Australia ($$$$$$).

I ending up fabricating my own skid plates for the transmission pan and to replace the plastic OEM "plate". It was a low cost mod, when you DIY. I use 6061 for the flat, trans. pan and 5052 T6 for the sump plate (this one has a bend like the OEM plate). The 3/16 thickness has worked out well, not too thick so that it still bends when it gets bashed instead of tweaking the mounts.

Last edited by Inyo_man; 04/17/11 02:58 AM.
'02 Montero: OME suspension, ARB front bumper, homemade skid plates & spare tire Blitz can mount, extended diff. breather, K&N air filter, Optima Yellow Top, BajaRack, IPF lights, Goodyear Duratrac 265/75/16's, RUD 4x4 Grip chains