busted CV boot so I figure I'll go ahead and replace it. I've got it all loosened up and all and got it clear from the inboard flange, but where the axle slips out of the hub area I can't clear the lower suspension arm framework? I've jacked it up to try and adjust the angle of the suspension arm but it seems no matter how high I jack it up the whole truck raises and not so much "flattening" (for lack of a better term) the angle of the arm. If I could "flatten" that angle I think it will clear. I've done this before but I can't remember how I got around this issue. Any thoughts are more than I've got now. Thanks peeps! <img src="/forums/images/graemlins/cheers.gif" alt="" />