Zombie thread, eh?

I finally acquired good block/heads. A friend gave me block/heads from a Chrysler van.

I've swapped the oil pump, plugged the oil filter feed on the drivers side, plugged dipstick on drivers side, bored for dipstick on passenger side, swapped cams and roller cam setup.

I'm just about ready to put the heads on.

How far up should I build the engine before putting it back into the truck? I pulled the heads when the block was still in the truck. Can I get it back in with the intake on?

Last edited by m4ff3w; 06/11/12 02:50 AM.
92 Montero SR
84 Maserati Biturbo
89 Mercedes 190E
77 Fiat X1/9