Diagnosing lack of current at A/C compressor

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: Diagnosing lack of current at A/C compressor [Re: FrankR] #1030622 06/24/11 04:12 AM

Joined: Jan 2001

Posts: 13,649

Helen , GA

fasteddy

Web Wheeler

I was sitting on a job site one day watching concrete dry, and started listing out the current path for the a/c. It is more than complex. I had 4 columns on an 8.5x14 pad, and I was about half thru.

I'd follow Justice's advice above. It's what I'd check. My bet is that it leaked out and the low pressure switch is killing the compressor.

Not responsible for advice not taken...

Entire Thread
Subject	Posted By	Posted
Diagnosing lack of current at A/C compressor	sidecardog	06/23/11 08:27 PM
Re: Diagnosing lack of current at A/C compressor	sidecardog	06/23/11 10:30 PM
Re: Diagnosing lack of current at A/C compressor	justice	06/24/11 12:49 AM
Re: Diagnosing lack of current at A/C compressor	FrankR	06/24/11 01:57 AM
Re: Diagnosing lack of current at A/C compressor	fasteddy	06/24/11 04:12 AM
Re: Diagnosing lack of current at A/C compressor	JohnnyBfromPeoria	06/24/11 07:21 AM
Re: Diagnosing lack of current at A/C compressor	justice	06/24/11 03:16 PM
Re: Diagnosing lack of current at A/C compressor	sidecardog	06/24/11 05:19 PM

Moderated by 4x4Wire, Macka, Mudraider, off-roader, PHIL_, rxinhed

Hop To

4x4Wire Social: