Well , first day off in 2 weeks today and it was nice out so I took advantage to start my lift project. I got the rear upcountry springs swapped in and the coil spring spacers , but the new bumpstops were a pain , so am thinking of a way to pop them in.I think I will use some glue as I had them partially in but they kept popping back out , even using compression to pop them in.Other than that the rears are done and torqued down.
I then started on the front , took everything apart , got the passenger side spring out , but trying to get the new spring in just didn't want to work.I needed an extra 3/4" of compression or droop , which I could not get.I am going to have to get a set of coil spring compressors to get them smaller.My way of wrapping them with strong wire after compressing them didn't work , I just couldn't get enough on them.Hopefully the weather gets nice again so I can finish it off.The rear looks good , I will try and get some pictures tomorrow , but it is a little off with the front still jacked up on the stands.