Today I drained the oil , took the filter off , and guess what, it made no difference for room to get the passenger side header on.I ended up using my stock jack to push the trans over a little and soon as I did that it plopped right down into place.I have everything bolted together loosely right now , just need to torque it all in.I went and cut the stock pipe a little too much , now I will have to get a short piece of pipe too connect to the collector and the stock pipe going into the cat.Once all that is torqued in , it's just a matter of finishing up with the suspension , which comes down to the ball joints , tie rod ends , track bar and steering damper.Then will have an alignment done and we should be all good.