$100

'89 SWB v6 200k does not run
15x7 alloy wheels, 265x70/R15 tires w/ about 1/2 tread remaining. includes mitsu lug nuts and locks.

Engine has a broken timing belt and low compression in #6, hood is dented and no AC.

I held a delusion for a while that I would have time to fix it but I've given it up and it's time for the rig to go.

It's in Pleasanton, CA. come and get it.

-Kirk

Pictures?

It's welcome here if no one picks up the little guy. <img src="/forums/images/graemlins/smile.gif" alt="" />

man if this around here it would be in my driveway now. Sorry for your lost. Good Luck with your sale.

Damn... I want it, too but wrong area for me.

I'll take them. I've been looking for a V6 SWB to rebuild. I'm in the Sacto area and could be down later this week or weekend.

It's now at it's new home in Loomis. Thank you Kirk! I feel guilty taking it home for such a low price.

Now, I need to find a donor car for the drive train.
Drive train swap (either a GM 4.3 or a GM 3.8), 4l60e, and NP231c and all of the joys of mating them to the Mitsu.
Splice the GM A/C into the Mitsu system.
New sheet metal for the passenger side and front.
Quite a bit of small body work.
Go through and then install the SR rear axle I have laying around/wire up the compressor.
Have custom drive shafts built.
Install the locking hubs that I have.
Go through/replace the brakes
Clean/replace interior bits as needed.
Install the bouncy seat base I have laying around.
Prep for paint and respray the exterior.
Fabricate or buy armor protection and a winch front bumper.
Install the Superwinch EPi 9.0 that I have.
Plus a whole lot more I'm sure. I shall name it, "Little Blackie."

It's time to start finding bits and a drive train donor vehicle. I'm happy to be a Mitsubishi owner again!

Gonna change your signature then? <img src="/forums/images/graemlins/wink.gif" alt="" />

Done.