It's now at it's new home in Loomis. Thank you Kirk! I feel guilty taking it home for such a low price.

Now, I need to find a donor car for the drive train.
Drive train swap (either a GM 4.3 or a GM 3.8), 4l60e, and NP231c and all of the joys of mating them to the Mitsu.
Splice the GM A/C into the Mitsu system.
New sheet metal for the passenger side and front.
Quite a bit of small body work.
Go through and then install the SR rear axle I have laying around/wire up the compressor.
Have custom drive shafts built.
Install the locking hubs that I have.
Go through/replace the brakes
Clean/replace interior bits as needed.
Install the bouncy seat base I have laying around.
Prep for paint and respray the exterior.
Fabricate or buy armor protection and a winch front bumper.
Install the Superwinch EPi 9.0 that I have.
Plus a whole lot more I'm sure. I shall name it, "Little Blackie."

It's time to start finding bits and a drive train donor vehicle. I'm happy to be a Mitsubishi owner again!