ok dug into one, looks like it spun the rod bearings
[Linked Image]
[Linked Image]
why would a motor do this? it looks as if it has been rebuilet no to long ago.
i noticed as well that the caps for the rods 3 out of 4 were shaved/ground down?
[Linked Image]
[Linked Image]
and somthing eles all three motor have differnt lettes on the end caps this one has an A the other short block has F and the long block i thing was an E.???
one rod cap was taken off alread was finger tight on the other short block it to had spun the bearing it was a std. have not touch the long block


owned a few .. current 86 rustbucket 2.5td . manual hubs