Throw out bearing or input shaft bearing noise?

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: Throw out bearing or input shaft bearing noise? [Re: KrzyDav] #1046354 05/11/12 12:21 PM

Joined: Nov 2011

Posts: 218

METALMOVER Offline

Wheeler

Also Griz, after reading the archives I had seen where when you change the tranny fluid to add a "friction additive" to the tranny, it is suppose to make em shift a little better and if I remember correctly sold by Mittsubishi dealers, also Ive noticed on my manual when its real cold(like 10 below) it shifts real hard, dont worry though it goes away after it runs about a half an hour. Just a heads up. METALMOVER <img src="/forums/images/graemlins/patriot.gif" alt="" />

1987 Raider,2.6,mt,78"Meyer snow plow,100lb. Doberman alarm,weber carb, lockouts from here- 1989 V-6,SWB, A.T. 4x4, 31'S

Entire Thread
Subject	Posted By	Posted
Throw out bearing or input shaft bearing noise?	RaiderGriz	05/09/12 05:42 PM
Re: Throw out bearing or input shaft bearing noise?	KrzyDav	05/10/12 12:07 AM
Re: Throw out bearing or input shaft bearing noise?	RaiderGriz	05/10/12 04:47 AM
Re: Throw out bearing or input shaft bearing noise?	goobuds	05/10/12 05:13 AM
Re: Throw out bearing or input shaft bearing noise?	KrzyDav	05/10/12 05:21 AM
Re: Throw out bearing or input shaft bearing noise?	mike71800b	05/10/12 12:46 PM
Re: Throw out bearing or input shaft bearing noise?	RaiderGriz	05/10/12 07:08 PM
Re: Throw out bearing or input shaft bearing noise?	JohnnyBfromPeoria	05/10/12 07:49 PM
Re: Throw out bearing or input shaft bearing noise?	KrzyDav	05/11/12 04:13 AM
Re: Throw out bearing or input shaft bearing noise?	ES_97Sport	05/10/12 08:22 PM
Re: Throw out bearing or input shaft bearing noise?	KrzyDav	05/11/12 06:24 AM
Re: Throw out bearing or input shaft bearing noise?	METALMOVER	05/11/12 12:21 PM
Re: Throw out bearing or input shaft bearing noise?	RaiderGriz	05/11/12 08:47 PM
Re: Throw out bearing or input shaft bearing noise?	KrzyDav	05/12/12 07:03 AM

Moderated by 4x4Wire, Macka, Mudraider, off-roader, PHIL_, rxinhed

Hop To

4x4Wire Social: