Thanks Brian, I would like to hear more about your project for sure!!

This has been a really cool project. I have thought of using 272 cams(I've been looking).
They seem to be a rare in a used form. New all day long for 300-550$. I will keep looking
<img src="/forums/images/graemlins/smile.gif" alt="" />
Also I was looking into the cyclone intake, They are a little hard to come by. I was looking into the sheet metal evo 3 setup, because the TB is in the correct location and no mods are really needed. I really like input if anyone has tested one. I want to make good Torque numbers down below 2500 RPM so the intake is important.
As for the ecu I wasn't to worried about boost control at this point. I do have a sweet manual setup now that works really well. Having all the data at my finger tips will help me really dial this thing in. I bought a nice 10.1 led laptop just for this setup. I will be able to tune anywhere I go <img src="/forums/images/graemlins/kewl.gif" alt="" />
Speaking of that, I will post a bench top Ecu flashing setup Soon. Thanks again for your input it is really appreciated.


I was looking around utube today and found this gem.
This thing is a beast!
https://www.youtube.com/watch?v=HkDe4AdgW5Y