The 119ft/lb is to pre-load the bearings. You don't leave there. Read the FSM all the way through. You set the pre-load, back off until loose, tighten again to something way less, and then another quarter turn. (Or something to that effect.)

What Eddy was talking about above was doing it by feel without the pre-load.


Big Truck: 00, 3.5, Endeavor, 5-Spd drive line in hand!
Little Truck: 87, 2.6T I/C, MT, LSDs, Tonneau Top
Her Truck: 03, 3.8, 20th Anniv, 65k
Daughter's: 06 Eclipse, Keeping it Mitsu!
FSMs: MitsubishiLinks.com