Intake/Exhaust Nuts ?'s

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: Intake/Exhaust Nuts ?'s [Re: MontyMcV] #1051431 09/14/12 02:23 PM

Joined: Jan 2001

Posts: 13,649

Helen , GA

fasteddy

Web Wheeler

Exhaust side are special locking nuts from dealer. Intake are plain vanilla.

You need to cut the webs between ports on exh mani and make sure the gasket surface is flat afterwards to keep from pulling out had studs.

Not responsible for advice not taken...

Entire Thread
Subject	Posted By	Posted
Intake/Exhaust Nuts ?'s	gavin	09/14/12 02:25 AM
Re: Intake/Exhaust Nuts ?'s	rxinhed	09/14/12 03:48 AM
Re: Intake/Exhaust Nuts ?'s	gavin	09/14/12 04:15 AM
Re: Intake/Exhaust Nuts ?'s	MontyMcV	09/14/12 12:09 PM
Re: Intake/Exhaust Nuts ?'s	fasteddy	09/14/12 02:23 PM

Moderated by 4x4Wire, Macka, Mudraider, off-roader, PHIL_, rxinhed

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 3.452s Queries: 16 (3.450s) Memory: 0.6018 MB (Peak: 0.6348 MB) Data Comp: Off Server Time: 2026-06-23 13:39:57 UTC
Valid HTML 5 and Valid CSS