Quote
Well I got the engine (block and head only)swapped over from the 97 to the 2000. Runs OK, it seems like its a little slow to rev up when taking off sometimes. I am also getting a couple of codes P0326 wich is the knock sensor. I ended up using the knock sensor from the 97 because the one from the 2000 fell apart when I removed the bolt attaching it to the block. They looked the same but there were no part numbers to verify. I havent had a chance to get to the parts store to verify if they are the same or not. Does anybody know? Also P0717 speed sensor A circut no signal. Im guessing the speed sensor may have come unplugged or the wire was damaged. Ill get it back on the lift tomorrow. We did remove the tranny to make it easier to get the engine wiring hooked back up easier. Any other ideas? Also the hold light is flashing and hitting the button does nothing. Im guessing it may be related to the speed sensor, but I dont know.p1624 is also showing but from what Ive read that is a generic code from either the ECM or TCM telling the CEL to light. If anybody has any other ideas Im all ears.


to me it kinda sounds like a possible ground issue...


"Does this part need to be in there?"

1996 Dodge 1500 single cab / short bed, 5.9 4x4; 2" lift (springs not blocks), C.A.I and more mods to come.