TBAR CRANK! I've been reading about this since I bought my first Montero but never actually did one. I searched around for pictures but could not find any. I spent way too much time trying to find the correct adjustment bolt. I feel like a total newb! After attempting to tighten the large (incorrect) 22mm nuts up front I found some instructions on how to do this on a Chevy S10 and applied it to the Montero.


So, if anyone out there has not yet done a TBAR crank, the correct bolt is a 17mm near the rear of the TBAR. The 17mm head faces the ground. To lift the front 1.25" I cranked each side approximately 40 revolutions. I stared with the front of the truck in the air and finished with it on the ground, so either way will work fine. Here is before taken today: [Linked Image]

Attached Files
1283005-montybefore.jpg (0 Bytes, 33 downloads)
Last edited by MBrannon; 09/15/13 02:50 AM.