Well, I have begun to make some progress. its a little slow. but it will get there. a lot of thinking in between jobs on how to make it look as factory as possible.

Started by tacking welding the rear panel in place, along with the 3mm flat bar that holds it all in place The bottom corner will be filled with plate when I get some.






I cut a section out of the old rear end and tacked it into place to set the corner. I am really trying to follow the factory lines. will require a bit of extra work, as the angle goes up to steep







Following the lines:


I figure I am going to start at the roof instead of the floor, the angles will be much easier to deal with. straight edge for the back of the cab: