Jack handle placement in the Gen 1 two door

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: Jack handle placement in the Gen 1 two door [Re: off-roader] #1065320 10/28/13 11:14 PM

Joined: Feb 2005

Posts: 2,649

Livermore, Ca

Grasscat

Roll Me Over

I thought that also, but there is no clips and it shows no sign of there being any hole where the clips may have been.
I posted it was a Gen 1, but it's a 89 two door Raider. Maybe there is some difference between them, but I would not think so.

Michael j

TreadLightly! Trainer

Grasscat III, 1994 Gen 2 Five speed, Stock ( for a little while )

GrassCat II, 1998 Gen 2.5 Locked and loaded. Ran off with Hector.

GrassCat I, 1991 Gen 1 Ran off with Justice.

Entire Thread
Subject	Posted By	Posted
Jack handle placement in the Gen 1 two door	Grasscat	10/28/13 05:21 PM
Re: Jack handle placement in the Gen 1 two door	off-roader	10/28/13 06:19 PM
Re: Jack handle placement in the Gen 1 two door	Grasscat	10/28/13 11:14 PM
Re: Jack handle placement in the Gen 1 two door	JAVYPRO	10/28/13 11:24 PM
Re: Jack handle placement in the Gen 1 two door	rxinhed	10/29/13 02:30 AM
Re: Jack handle placement in the Gen 1 two door	off-roader	10/29/13 02:44 AM
Re: Jack handle placement in the Gen 1 two door	MarkG	10/29/13 03:13 AM
Re: Jack handle placement in the Gen 1 two door	rxinhed	10/29/13 05:04 AM
Re: Jack handle placement in the Gen 1 two door	Grasscat	10/29/13 05:31 AM
Re: Jack handle placement in the Gen 1 two door	rxinhed	10/30/13 12:27 AM

Moderated by 4x4Wire, Macka, Mudraider, off-roader, PHIL_, rxinhed

Hop To

4x4Wire Social: