|
|
|
|
 1995 SR Parts Needed
#1067512
12/24/13 08:16 PM
|
Joined: May 2013
Posts: 46
OP
Getting the Wheeling Fever
|
Replacing the timing belt on my 1994 Montero SR (3.5L 6G74)and discovered that most of the 10mm bolt holes that hold the water pump to the water pump housing are stripped. Looked in ASA and it doesn't show the part number for the housing that the water pump goes into, only the water pump itself. The bigger 14MM bolts that go into the engine block are fine. Would rather be proactive and have the part available because I figure this will be a problem down the road if I ignore it. Is this a part number anybody has and that I order a replacement for or am I going to have to find one in a junk yard?
Another part I discovered a stripped bolt hole on was the power steering pump, I found the part number for it (MB922960) and this was already on my list of things to replace because it seems to leak oil all over that side of the engine anyway.
Sean - Just a few miles south of Hell, AZ
[color:"blue"]Current Project: 1994 Montero SR recently not smoking, in need of offroad mods.[/color]
|
|
|
Re: 1995 SR Parts Needed
[Re: Torchwood]
#1067513
12/24/13 09:42 PM
|
Joined: Dec 2004
Posts: 949
Rock Warrior
|
|
|
|
|
Re: 1995 SR Parts Needed
[Re: Monty]
#1067514
12/24/13 10:11 PM
|
Joined: Jan 2001
Posts: 13,649
Web Wheeler
|
The ASA part image shows the whole pump set with gaskets, front and back halves. I've bought aftermarket with both, too.
Not responsible for advice not taken...
|
|
|
Re: 1995 SR Parts Needed
[Re: fasteddy]
#1067515
12/25/13 06:31 AM
|
Joined: Apr 2006
Posts: 1,193
Body Damage is Cool
|
i have a water pump housing send your mailing address
it dosent have to be surrounded by water to be an island
|
|
|
Re: 1995 SR Parts Needed
[Re: mxmikie]
#1067516
12/30/13 01:16 PM
|
Joined: Apr 2006
Posts: 1,193
Body Damage is Cool
|
pm sent did you get it ???
it dosent have to be surrounded by water to be an island
|
|
|
Re: 1995 SR Parts Needed
[Re: Torchwood]
#1067517
01/04/14 03:10 PM
|
Joined: Apr 2006
Posts: 1,193
Body Damage is Cool
|
Replacing the timing belt on my 1994 Montero SR (3.5L 6G74)and discovered that most of the 10mm bolt holes that hold the water pump to the water pump housing are stripped. Looked in ASA and it doesn't show the part number for the housing that the water pump goes into, only the water pump itself. The bigger 14MM bolts that go into the engine block are fine. Would rather be proactive and have the part available because I figure this will be a problem down the road if I ignore it. Is this a part number anybody has and that I order a replacement for or am I going to have to find one in a junk yard?
Another part I discovered a stripped bolt hole on was the power steering pump, I found the part number for it (MB922960) and this was already on my list of things to replace because it seems to leak oil all over that side of the engine anyway. hey buddy i sent you a water pump housing did you get it ???
it dosent have to be surrounded by water to be an island
|
|
|
|
|
|
OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
PHP: 7.4.33 Page Time: 0.006s Queries: 15 (0.004s) Memory: 0.6076 MB (Peak: 0.6772 MB) Data Comp: Off Server Time: 2026-06-17 16:01:28 UTCValid HTML 5 and Valid CSS 
