Gen 1 crankshaft pulley

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: Gen 1 crankshaft pulley [Re: BottomFeeder] #1074265 09/13/14 12:02 AM

Joined: Jan 2001

Posts: 13,649

Helen , GA

fasteddy

Web Wheeler

It has to be two piece. It's a harmonic balancer and the rubber insert absorbs the harmonic vibrations from the crank, and if it wasn't there, there is a large chance of crank breakage when the torsional vibrations reach a harmonic and amplify to dangerous levels.

Not responsible for advice not taken...

Entire Thread
Subject	Posted By	Posted
Gen 1 crankshaft pulley	BottomFeeder	09/12/14 11:52 PM
Re: Gen 1 crankshaft pulley	fasteddy	09/13/14 12:02 AM
Re: Gen 1 crankshaft pulley	rxinhed	09/13/14 04:32 AM
Re: Gen 1 crankshaft pulley	BottomFeeder	09/13/14 03:12 PM
Re: Gen 1 crankshaft pulley	BottomFeeder	09/14/14 11:50 PM
Re: Gen 1 crankshaft pulley	danz91crx	09/15/14 01:10 AM
Re: Gen 1 crankshaft pulley	fasteddy	09/15/14 01:28 AM
Re: Gen 1 crankshaft pulley	KrzyDav	09/15/14 06:56 AM
Re: Gen 1 crankshaft pulley	BottomFeeder	09/17/14 02:12 AM
Re: Gen 1 crankshaft pulley	KrzyDav	09/17/14 08:20 AM

Moderated by 4x4Wire, Macka, Mudraider, off-roader, PHIL_, rxinhed

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 3.590s Queries: 16 (3.588s) Memory: 0.6137 MB (Peak: 0.6467 MB) Data Comp: Off Server Time: 2026-05-28 05:35:10 UTC
Valid HTML 5 and Valid CSS