Rotor thickness

Brake info from a long time ago... And advice about mismatched parts.

Pad Slippage Yes it did happen.

Point taken and I will be sourcing gen2 rotors, however I have worn a set of pads sence the swap, replaced them around 1.5mm without coming even close to pads coming out of the bracket. I machined the rotors and only need one pass the resurface so that indicates no warpage what so ever less then .002in off each side, this was done pretty recently. So I do agree the potential for disaster is there as rotors and pads get closer to discard. The difference may have been the brand new gen1 rotors before doing the gen2 calipers also driving habbits may play a factor. I tow rarely and when I do it's a small trailer with lighter loads. Sorry for the bad advise, just speaking from experience.

Brake Dimensions and Calculations