Recently I asked about welded gears, and got a lot of feedback. I am going to go ahead and weld them up. I pretty much had my mind made up about what kind of axles I was going to run. Then I was looking around online and ran across a portal axle image. I have never seen one in person. And what I can figure they are hard to find. Upon researching those I seen a atomic axle. Right away I liked it. I seen a couple homemade ones. Am I the only one who thinks you can turn a factory ifs into type of atomic axle. And getting a second front ifs unit and do it the sameway and put it on the rear, and make it 4x4x4?