Trailing arm bushing change tools needed

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: Trailing arm bushing change tools needed [Re: MI_Mitsu] #1076535 01/27/15 10:27 PM

Joined: Feb 2001

Posts: 2,356

Scaly Mountain, NC, USA

MarkG

Body Damage is Cool

Both tools look familiar. I probably have both. I may take me a day or so to look.

I believe the point of the service manual is for the bushings to be nearly centered in the trailing arm. I believe the MB991293 has a threaded shaft and a nut that will pull the bushing into the trailing arm. One could probably make up a similar arrangement with a long bolt and some nuts. One could also get the same thing done with a press.

Mitsu # 6 - 98 6G72 Montero Sport, Locking Rear Diff, Aisin Manual Hubs, 31x10.5

Mitsu # 7 - 02 6G74 Montero Limited

Entire Thread
Subject	Posted By	Posted
Trailing arm bushing change tools needed	MI_Mitsu	01/27/15 09:55 PM
Re: Trailing arm bushing change tools needed	jdavis	01/27/15 10:21 PM
Re: Trailing arm bushing change tools needed	Jeep2Montero	01/28/15 09:25 AM
Re: Trailing arm bushing change tools needed	jdavis	01/28/15 09:11 PM
Re: Trailing arm bushing change tools needed	MarkG	02/08/15 05:57 PM
Re: Trailing arm bushing change tools needed	MI_Mitsu	02/11/15 11:47 PM
Re: Trailing arm bushing change tools needed	JohnnyBfromPeoria	02/12/15 02:22 AM
Re: Trailing arm bushing change tools needed	ryany	02/15/15 03:11 AM
Re: Trailing arm bushing change tools needed	JohnnyBfromPeoria	02/15/15 04:04 PM
Re: Trailing arm bushing change tools needed	MarkG	01/27/15 10:27 PM

Moderated by 4x4Wire, Macka, Mudraider, off-roader, PHIL_, rxinhed

Hop To

4x4Wire Social: