|
|
|
|
 need good distributor 3.0 1989
#1079751
12/23/15 09:10 PM
|
Joined: Mar 2008
Posts: 95
OP
Getting the Wheeling Fever
|
looking for good distributor for 89 3.0. OR ideas why it won't start. I just had engine swapped and newer engine had a dist that would not plug into my wiring harness. Guy says he changed the coil and ICM, but won't start. He says fire is going out of coil, but not thru dist. Charlie (Old Colt) thinks he may have timing off 180. Any other ideas? Dist was working when the bottom end went.
Last edited by bearingman; 12/23/15 09:11 PM.
|
|
|
Re: need good distributor 3.0 1989
[Re: bearingman]
#1079753
12/24/15 12:41 AM
|
Joined: Mar 2008
Posts: 95
OP
Getting the Wheeling Fever
|
crank angle sensor???? Available seperate?
|
|
 Re: need good distributor 3.0 1989
[Re: bearingman]
#1079771
12/30/15 09:54 PM
|
Joined: Mar 2008
Posts: 95
OP
Getting the Wheeling Fever
|
:)turns out it was just a wire in harness. Got it straight. :mad: :cry: but the crank/bearings are bad. moves in place about 1/16"
|
|
|
|
|
|
OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
PHP: 7.4.33 Page Time: 0.009s Queries: 15 (0.007s) Memory: 0.5889 MB (Peak: 0.6421 MB) Data Comp: Off Server Time: 2026-07-14 12:28:03 UTCValid HTML 5 and Valid CSS 
