Well, that might have been a pain, oH, and looking at it I probably could have threaded the sensor wire through. Anyway, plugging in the injectors today, and one set is blue, and one is brown, and the manual doesn't say which was which, fortunately, I took pictures, and in the corner of one pic I could see the connector for one of the pass side injectors, and it was brown, which is opposite of the way I had it setup, so... Ya, small issues, could have been a real pain later. Oh, well there was the usual dropping things down below the lower intake manifold, one injector clip, and two of the plastic isolators... which being plastic, ignored the magnet... lol