Head Machining Tolerances?

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: Head Machining Tolerances? [Re: Mudraider] #1103281 04/04/17 01:43 PM

Joined: Mar 2005

Posts: 1,006

South East U.S.A.

pcc

Body Damage is Cool

Thanks for reply.

Took it to the machine shop today, machinist says it's usually not a problem up to .010, then he said there are HG shims that fit under HG to raise head. I think I'll be alright. Will see how much he shaved head by.

92 Montero LS 3.0L V6 Auto, Stock, Original owner, 185,800K miles

Entire Thread
Subject	Posted By	Posted
Head Machining Tolerances?	pcc	03/31/17 12:10 AM
Re: Head Machining Tolerances?	Mudraider	04/04/17 01:28 PM
Re: Head Machining Tolerances?	pcc	04/04/17 01:43 PM
Re: Head Machining Tolerances?	Mudraider	04/06/17 01:38 AM
Re: Head Machining Tolerances?	pcc	04/06/17 05:30 PM

Moderated by 4x4Wire, Macka, Mudraider, off-roader, PHIL_, rxinhed

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 6.150s Queries: 16 (3.528s) Memory: 0.6011 MB (Peak: 0.6341 MB) Data Comp: Off Server Time: 2026-06-24 20:11:52 UTC
Valid HTML 5 and Valid CSS